The first five are Egypt-themed, then space, then a mansion, and finally a corporate office. Each level consists of five rooms that are thematically connected. Pull the hatchet lever and leave the room.Escape Simulator does a lot of things we’ve seen before from other escape room games, but it adds some clever mechanics that help support the cooperative nature of the game.Grab one of the tools on the Toolbox, remove the pressure lid and place the sequence described in the picture above.Get the Fuse(25) again and place it on the hatchet lever.Remove the broken fuse and place the following Fuses: 30-25-20-15.Get the Screwdriver from the toolbag and use it to open the lid on top of the suit.Open the lid in middle of the drawers and place a Fuse(15) in each slot.Open the rest of the drawers and pick up the fuses and Safety Tether.In the keypad on the drawer put : 384.Open the cabinet with the poster and grab the Helmet, Toolbag and Fuses.To speedrun this room, try to do all of the things below as soon as possible:°Pick up the Pyramidion Part on the floor. The token is on the top right corner of the vent. On top of the door that you use to exit the level there is a sign that reads D-4.The token is where the tank gas is attached. There is an oxygen tank right from the suit, remove it.Below the monitor that says ship terminal.On the last drawer inside the cabinet where the helmet was, crouch to get the right angle.On the floor, right where the suit was.On the seats below the pressure panel, left side close to the wall.Right from the red box where it says coolant sensor, hiding behind cables.There are eight tokens that can be found in this level: ![]() Note: All credits for the walkthrough go to Neoseeker. Get in the suit and remove the Fuse(25) to put it again in the hatch lever. The correct fuses to use are : Fuses 30-25-20-15. Keep in mind that the green stained fuse will not work and you will need to grab a Fuse(25) from the hatch lever. Use the screwdriver to open the lid on top of the suit and place the fuses you need to get to 90. Start building the suit by using the Display, Safety Tether, Helmet and before putting the Toolbag there, grab the Screwdriver inside. ![]() The standard operating temperature is listed on the monitor. Look to the window on your right and you will notice that you are floating on Stargazer 28 ship. The correct sequence is in the picture below.Ĭlick the projector on the glass protecting the suit, it will give you clues on how to open the door. You will need to input the right sequence to balance the pressure on the cabin. ![]() Use one of the tools to open the lid on the pressure panel. Pick up the tools in the Toolbox and the Display. To open the drawer with the keypad on it, you need to look at your tablet and at the safety rules poster in the cabinet behind you. Remove the lid on the middle of the drawers and place the one Fuse(15) in the oxygen sensor and one Fuse(15) in the coolant sensor as it says on one of the tablets. Open the drawer on the left too and pick up another Fuse and another Open the next drawer and pick up more Fuse and the Safety Tether. Pick up the Tablet on the sits and go to the other side of the room. Start by opening the cabinet on your right and grab the Toolbag, the Helmet and the Fuses.
0 Comments
Leave a Reply. |